介紹了用于山東通風管道標識風壓計算方法

發布人：http://m.hwzxw.net   發布時間：2019-07-16 16:49:37

　　風壓計算用的風道標簽是什么?，長距離掘進巷道通風時，風道進、出口風量差和風壓差較大。為了選擇合理的風機通風方式，有必要研究風道風量和風壓的變化規律。傳統的方法是通過經驗或?qū)嶒?yàn)得到管道接頭的平均泄漏風量，從而計算進氣道的風量和壓力。但是，對于長距離通風和各風道體積小，該方法計算的參數相對較小，會造成風機選型誤差。

　　What is the label of the air duct used for calculating the air pressure? When ventilating long-distance tunnels, the air volume difference between the inlet and outlet of the air duct and the air pressure difference are large. In order to choose a reasonable ventilation mode of fan, it is necessary to study the variation law of air volume and pressure in the duct. The traditional method is to get the average leakage air volume of the pipe joint through experience or experiment, so as to calculate the air volume and pressure of the intake port. However, for the long-distance ventilation and the small volume of each duct, the parameters calculated by this method are relatively small, which will cause the error of fan selection.

　　山東通風管道

　　Shandong Ventilation Pipeline

　　根據風量和空氣壓力平衡定律,風量的關系,空氣壓力和進氣口的空氣出口推導出根據不連續通風網絡模型,并給出簡化的近似關系作為一種新的方法來計算通風參數的風道。結合具體算例，發現參數的近似值與精確值高度相似，說明可以用近似關系進行計算，簡單方便。結果表明，采用該方法計算長距離隧道的風量和風壓更加科學。

　　According to the law of air volume and air pressure balance, the relationship between air volume, air pressure and air outlet of air inlet, the model of discontinuous ventilation network is deduced, and the simplified approximate relationship is given as a new method to calculate the ventilation parameters of air duct. Combining with a specific example, it is found that the approximate values of the parameters are highly similar to the exact values, which indicates that the approximate relationship can be used to calculate the parameters, which is simple and convenient. The results show that the method is more scientific in calculating wind volume and pressure of long-distance tunnels.

　　山東通風管道

　　Shandong Ventilation Pipeline

　　通風機是一種耗能大、體積大、占地面積廣的設備。為節約風機能耗，降低運行成本，當前應重視通風空調系統的優化技術，以降低系統風道壓降和消耗，合理匹配和優化運行調節。作者發現,從風機現場售后服務質量問題之前,業主決定,風扇,風扇使用現場調查,結果相當部分是不合理的通風系統設計、制造、安裝和導致風機運行異常,出現通風機性能不能滿足設計要求,過量的噪音、振動葉片斷裂問題的通風系統改革后,風機正常運行。

　　Fan is a kind of equipment with large energy consumption, large volume and wide area. In order to save energy consumption of fans and reduce operating costs, attention should be paid to the optimization technology of ventilation and air conditioning system, in order to reduce the pressure drop and consumption of air ducts, rationally match and optimize operation regulation. The author found that before the quality of after-sales service of fans, the owners decided to investigate the use of fans and fans. The results showed that quite a part of unreasonable ventilation system design, manufacture, installation and abnormal operation of fans resulted in the failure of fan performance to meet the design requirements, excessive noise and ventilation with vibration blade breakage. After the system reform, the fan operates normally.

　　以上是山東通風管道廠家為大家整理的相關內容，想要了解更多內容，歡迎訪問網站：http://m.hwzxw.net

　　The above is the related content of Shandong Ventilation Pipeline Factory for you. For more information, please visit the website: http://m.hwzxw.net.